Teledyne LeCroy STX M6-1 SAS_SATA Protocol Analyzer User Manual - Manual (Page 67)

Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual 65
Easy Mode (Pre‐Defined Setups) LeCroy Corporation
SSP Frame (SAS only)
Double‐click SSP Frame to open the SSP Frame Pattern dialog.
Figure 2.25: SSP Frame Type Dialog
SAS vs. SATA: Not available in SATA.
Click the down arrow next to the SSP Frame Type list box and choose an SSP Frame type.
FIS (SATA only)
Double‐click FIS (Frame Information Structure) to open the FIS Type selection dialog.
SAS vs. SATA: Not available in SAS.
Click the down arrow next to the Type drop‐down list box, choose a FIS type to capture,
and click OK. Repeat for additional types.
Available FIS Types:
 Register Host to Device
 Register Device to Host
 Set Device Bit
 DMA Activate
 DMA Setup
 BIST
 PIO Setup
 Data
 Any Type