Teledyne LeCroy STX M6-1 SAS_SATA Protocol Analyzer User Manual - Manual (Page 37)

Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual 35
Connecting via Ethernet LeCroy Corporation
6. Repeat steps 4 and 5 approximately three times, until the card is free from the
retaining screws and you can remove the card from the system.
Connecting via Ethernet
The Ethernet connection can have any of these configurations:
1. Analyzer connected to a network using a hub, switch, Gigabit Ethernet interface, or
similar device.
2. Analyzer connected to the host computer (machine running the application
software), using a hub, switch, Gigabit Ethernet interface, or similar device.
3. Analyzer connected directly to the host computer using a crossover cable.
Connecting to a Network
When connected to a network, the analyzer can communicate with the DHCP server to
establish a connection. The DHCP server continually sends the next available IP address to
the analyzer until the software starts.