Teledyne LeCroy STX M6-1 SAS_SATA Protocol Analyzer User Manual User Manual
Page 99
Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual
97
Easy Mode (Pre‐Defined Setups)
LeCroy Corporation
The dialog shows the current port configuration. To select a port configuration, click the
down arrow to display the Select Port Configuration dialog.
Figure 2.70: SAS: Select Port Configuration Dialog
Port configuration depends on the application you run.
To act as analyzer, select the
Analyzer port configuration.
To activate a Device emulator on a port, select the
TargetEmulator port configuration.
To activate the Initiator Emulator on a port and run the Analyzer on the same
port, select
InitiatorEmulator/Analyzer.
To activate the InFusion on a port, select
Jammer.
To activate the Trainer on a port, select
Trainer.
Sierra M6‐2 can have Analyzer and Trainer or Analyzer and Jammer on the same port.
Note:
To display the current Port Configuration, click the green button in the lower right corner to
display the Port Status window (see
).