Vanguard CT-8000 - Manual (Page 30)

CT-8000 USER’S MANUAL REV 2
25
3.2.4. Setting the Units of Measure
The CT-8000 supports and displays both English and Metric calculations. You can switch
between the English and Metric systems using the steps below:
a. Start from the “START-UP” menu:
Press the
[3]
key (SETUP).
b. The following screen will be displayed:
Press the [2] key (MEASUREMENT UNITS).
c. The following screen will be displayed:
Press the [1] key (ENGLISH) or the [2] key (METRIC) to select the corresponding
measurement system. The measurement system will be set and you will be returned to
the “START-UP” menu.
NOTE
If the measurement system is changed, any relevant values in the working
memory will be automatically converted to the new system. Also, if retrieving
a test record from the Flash EEPROM, all data will be converted to the new
measurement system. There is no need to re-run a test.
SELECT UNITS:
1. ENGLISH
2. METRIC
3. ROT ENC 4.RES ENC
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SAVE / RESTORE
4. NEXT PAGE
1. RUN TEST 03/10/10
2. GET RSLT 09:04:05
3. SETUP
4. DIAGNOSTICS