Vanguard CT-8000 User Manual
Page 50
CT-8000 USER’S MANUAL
REV 2
45
NOTE
If there is no setup stored in the selected memory location, the following
screen will be displayed:
Press any key to return to the “START-UP” menu.
f. The following screen will be displayed:
Press the
[ENTER]
key to load the selected setup.
g. The following screen will be displayed:
Press any key to return to the “START-UP” menu.
Printing a Resistor Type Transducer Setup Directory
You can print a directory of the stored resistor type transducer setups on the built-in thermal
printer using the steps below:
a. Start from the “START-UP” menu:
Press the
[3]
key (SETUP).
b. The following screen will be displayed:
Press the
[2]
key (MEASUREMENT UNITS).
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SAVE / RESTORE
4. NEXT PAGE
1. RUN TEST 03/10/10
2. GET RSLT 09:04:05
3. SETUP
4. DIAGNOSTICS
SETUP LOADED!
SETUP NUMBER: 1
NOTE
ENGLISH
“ENTER” TO CONTINUE
SETUP NOT FOUND