Vanguard CT-8000 - Manual (Page 93)

REV 2 CT-8000 USER’S MANUAL
88
b. The following screen will be displayed:
Press the
[1]
key (ANALYSIS POINTS).
c. The following screen will be displayed:
Press the [4] key (TEST PLANS).
d. The following screen will be displayed:
Press the [1] key (LOAD TEST PLAN).
e. The first test plan stored in the CT-8000’s Flash EEPROM will be listed:
You can scroll through the list of test plans by pressing the [PAPER ∧ Contrast] and
[PAPER ∨ Contrast] keys. Once you have located the test plan that you would like to
load, press the [ENTER] key. The test plan will be loaded and you will be returned to
the “START-UP” menu. The test plan will be used for all subsequent timing tests. A
typical test results printout with Pass/Fail indicators is shown in Figure 35.
NOTE
The following screen will be displayed if there are no test plans stored in the
CT-8000’s Flash EEPROM:
Press the
[ENTER]
key to return to the “START-UP” menu.
NO TEST PLANS FOUND
“ENTER” TO CONTINUE
TEST PLAN # 01
BZO-145-20-7
SIEMENS
DEMO TEST PLAN 1
1. LOAD TEST PLAN
2. PRINT TEST PLAN
3. PRINT DIRECTORY
1. OPEN TIMING
2. CLOSE TIMING
3. PRINT SETTINGS
4. TEST PLANS
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SAVE / RESTORE
4. NEXT PAGE