Vanguard CT-8000 - Manual (Page 47)

REV 2 CT-8000 USER’S MANUAL
42
e. The following screen will be displayed:
Press the
[1]
key to enter the transducer travel distance per volt using English units, or
press the
[2]
key to enter the transducer travel distance per volt using Metric units.
f. The following screen will be displayed:
Move the transducer to the reference position and press the [ENTER] key.
g. The following screen will be displayed:
Move the transducer a known distance and press the
[ENTER]
key.
h. The following screen will be displayed (the units of measure displayed will depend on
your choice in step e):
Using the numeric keypad, enter the distance the transducer was moved and then press
the
[ENTER] key.
i. The following screen will be displayed:
If you prefer, you can enter a note to be associated with the setup using the alpha-
numeric keypad. Press the
[ENTER] key when done typing.
ENTER SETUP NOTE:
↑↓ TO POSITION
“ENTER” TO ACCEPT
ENTER THE DISTANCE
MOVED:
IN
“ENTER” TO CONTINUE
MOVE RES ENCODER A
KNOWN DISTANCE...
“ENTER” TO CONTINUE
MOVE RES ENCODER TO
REFERENCE POSITION.
“ENTER” TO CONTINUE
RESISTIVE ENCODER
1. ENGLISH (IN/Volt)
2. METRIC (MM/Volt)