Vanguard CT-8000 - Manual (Page 46)

CT-8000 USER’S MANUAL REV 2
41
3.2.11. Configuring the Resister Type Transducer Settings
The CT-8000 provides one channel for a resistor type transducer. The transducer must be
configured before it can be used with the CT-8000. Up to 9 resistor transducer setups can be
stored in the CT-8000’s Flash EEPROM. When a resistive transducer is used with the CT-8000, it
is shown as transducer #1 on the timing report as shown in Figure 17.
Creating a New Resistor Type Transducer Setup
Follow the steps below to create a new resistor type transducer setup:
a. Start from the “START-UP” menu:
Press the [3] key (SETUP).
b. The following screen will be displayed:
Press the [2] key (MEASUREMENT UNITS).
c. The following screen will be displayed:
Press the
[4]
key (RES ENC).
d. The following screen will be displayed:
Press the [1] key (CREATE NEW SETUP).
RESISTIVE ENCODER
1. CREATE NEW SETUP
2. LOAD SETUP
3. PRINT SETUP DIR
SELECT UNITS:
1. ENGLISH
2. METRIC
3. ROT ENC 4.RES ENC
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SAVE / RESTORE
4. NEXT PAGE
1. RUN TEST 03/10/10
2. GET RSLT 09:04:05
3. SETUP
4. DIAGNOSTICS