Vanguard CT-8000 - Manual (Page 97)

REV 2 CT-8000 USER’S MANUAL
92
3.7.3. Printing a Breaker Test Plan
Follow the steps below to print a breaker test plan stored in the CT-8000’s Flash EEPROM:
a. Start from the “START-UP” menu:
Press the [3] key (SETUP).
b. The following screen will be displayed:
Press the [1] key (ANALYSIS POINTS).
c. The following screen will be displayed:
Press the [4] key (TEST PLANS).
d. The following screen will be displayed:
Press the
[2]
key (PRINT TEST PLAN).
e. The first test plan stored in the CT-8000’s Flash EEPROM will be listed:
You can scroll through the list of test plans by pressing the [PAPER ∧ Contrast] and
[PAPER ∨ Contrast] keys. Once you have located the test plan that you would like to
print, press the
[ENTER]
key. The test plan will be printed on the built-in thermal
printer and you will be returned to the “START-UP” menu. A sample breaker test plan
printout is shown in Figure 37.
TEST PLAN # 01
BZO-145-20-7
SIEMENS
DEMO TEST PLAN 1
1. LOAD TEST PLAN
2. PRINT TEST PLAN
3. PRINT DIRECTORY
1. OPEN TIMING
2. CLOSE TIMING
3. PRINT SETTINGS
4. TEST PLANS
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SAVE / RESTORE
4. NEXT PAGE
1. RUN TEST 03/10/10
2. GET RSLT 09:04:05
3. SETUP
4. DIAGNOSTICS