Vanguard CT-8000 - Manual (Page 89)

REV 2 CT-8000 USER’S MANUAL
84
3.6.4. Deleting Test Records from the Flash EEPROM
You can delete one or all test records stored in the CT-8000’s Flash EEPROM. To delete test
records:
a. Start from the “START-UP” menu:
Press the
[3]
key (SETUP).
b. The following screen will be displayed:
Press the [3] key (SAVE / RESTORE).
c. The following screen will be displayed:
Press the [4] key (ERASE SHOT).
d. The following screen will be displayed:
1. ERASE SHOT
Press the
[1]
key if you would like to erase a single shot from the Flash EEPROM.
The following screen will be displayed:
Using the numeric keypad, type the test record number that you would like to
erase. If you do not know the record number, you can first print a test record
directory using the instructions in section 3.6.2. Press the
[ENTER]
key.
ENTER SHOT NUMBER
TO BE ERASED
“ENTER” TO CONFIRM
1. ERASE SHOT
2. ERASE ALL SHOTS!
1. SAVE SHOT
2. RESTORE SHOT
3. SHOT DIRECTORY
4. ERASE SHOT
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SAVE / RESTORE
4. NEXT PAGE
1. RUN TEST 03/10/10
2. GET RSLT 09:04:05
3. SETUP
4. DIAGNOSTICS