Vanguard CT-8000 - Manual (Page 44)

CT-8000 USER’S MANUAL REV 2
39
3.2.10. Configuring the Digital Rotary Transducer Settings
A rotary transducer requires the user to enter the defined linear distance in millimeters or
inches per one degree of rotary motion. Follow the steps below to configure the settings for a
digital rotary transducer:
a. Start from the “START-UP” menu:
Press the
[3]
key (SETUP).
b. The following screen will be displayed:
Press the [2] key (MEASUREMENT UNITS).
c. The following screen will be displayed:
Press the
[3]
key (ROT ENC).
d. The following screen will be displayed:
1. ENGLISH (In./deg)
Press the [1] key to enter the rotary encoder linear distance per degree using
English units. The following screen will be displayed:
Type the desired value using the numeric keypad. You can press the
[CLEAR]
key
to reset the value to 0.000 In/Deg. Press the
[ENTER]
key to save the new value.
You will be returned to the “START-UP” menu.
INCHES/DEGREE
5.535 In/Deg
ROTARY ENCODER:
1. ENGLISH (In./deg)
2. METRIC (MM/deg)
SELECT UNITS
1. ENGLISH
2. METRIC
3. ROT ENC 4.RES ENC
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SAVE / RESTORE
4. NEXT PAGE
1. RUN TEST 03/10/10
2. GET RSLT 09:04:05
3. SETUP
4. DIAGNOSTICS