ZOLL E Series Monitor Defibrillator Rev R - Manual (Page 131)

9650-1210-01 Rev. R B-5
3. To deactivate automatic data transmission, display
the Summary menu (by pressing the SUMMARY
button) and press the Data Relay Off softkey
Note: If you change the destination port while a record
is already being transmitted, that transmission
continues to the previously selected port. All other
records in the queue will be transmitted to the
newly-selected port.
Note: If you change ports from Bluetooth to RS-232,
and then you want to change back to Bluetooth,
the host system must reestablish a connection
with the E Series unit. However, power to the
Bluetooth module is not turned on again until a
record starts transmitting out the Bluetooth port.
Transmitting 12-Lead Patient Records
You can transmit 12-lead ECG patient records to a
remote host system running ZOLL Data Relay software
without placing the E Series unit into Realtime mode.
1. With the E Series unit in Monitor mode (ON for AED
units), press the 12 Lead softkey to access the 12
Lead menu.
2. Press the PT Info softkey to access the Patient
Information menu.
3. Press the Patient Records softkey to display the
Patient Records menu.
4. Select a Patient record and press the Transmit
softkey.
5. Select the Data Relay option and press the Dial
Phone# softkey.
If you are transmitting via Bluetooth, then the green
power LED on the E Series unit illuminates. You must
now establish a connection between the host system
and the E Series unit.
Troubleshooting
If configured, the unit displays the following messages
when it encounters problems during data transmission.
01:20
12 LEAD MONITOR
ECG
24
NIBP
100
120
80
SpO2%
98
CO2 38 m
m Hg 24 RR
ECG II 120 x2
Acquire Settings Alar ms Retur n PT Info
01:22
24
NIBP
100
120
80
SpO2%
98
CO2 38 m
m Hg 24 RR
ECG II 120 x2
ID # Age
Patient
Records Retur n Gender
PATIENT INFORMATION :
Press Return to Exit to
12 Lead Monitor Mode
60 Male
Message Possible Causes and
Corrective Action
CARD FULL Data card is full. No more data
can be stored on the card, but the
unit continues to operate. This
prompt is only issued when the
unit is not analyzing or charging.
Insert another card, or print event
data on stripchart recorder.
INSERT CARD Card is not installed or not seated
properly in the unit.
CARD NOT
ERASED
PROPERLY /
ERASE CARD An Erase Card operation was
interrupted, or the card is
damaged. The unit operates, but
no data is being stored.
Erasing the card may allow return
to normal data storage operation.
CARD WRITE-
PROTECTED The card is write-protected. The
unit operates, but no data is
being stored.
Adjust the write-protect tab on
the card to allow writing.
14:07:32
Print
Record
Print
All
17 JUN 05
17 JUN 05
17 JUN 05
200506171407 14:07:32
11:52:48 200506171152
17 JUN 04
200506171324 13:24:03