Yokogawa Button Operated MV2000 - Manual (Page 171)

6-17
IM MV1000-01E
D
splay Conf
gurat
on
1
2
3
4
5
6
7
8
9
10
11
12
13
App
Index
• The scale is divided into 4 to 12 sections by the main scale marks. The section between
main scale marks is divided into 10 subsections by medium and small scale marks. Small
scale marks are not displayed if:
• The input range resolution is smaller than the total number of small scale marks.
• Zone display is enabled.
• Partially expanded display is enabled.
• The scale values are displayed according to the following rules.
• If the number of scale divisions is 4 to 7 for the vertical trend display, values are
displayed at all main scale marks. If the number of scale divisions is 8 to 12, the
values are displayed at every other main scale mark.
• Scale upper and lower limits are displayed at the ends of the scale.
• Scale values are displayed up to three digits, ignoring the minus sign. However, if the
integer parts of the values at the ends of the scale are both one digit or both is zero,
two digits are displayed.
Example: If the scale is –0.05 to 0.50, the lower limit will be –0.0 and the upper limit
will be 0.5.
• If the integer part of either end of the scale is two or three digits, the fractional part is
truncated.
Example: If the scale is 0.1 to 100.0, the lower limit will be 0 and the upper limit will be
100.
• If the integer part of either end of the scale is four or more digits, the value is
displayed using a 3-digit mantissa and an exponent, “×10” or “×10 2 ” for example.
Example: If the scale is 10 to 2000, the lower limit will be 1 and the upper limit will be
200×10.
• The unit is displayed near the center of the scale. If partially expanded display is enabled,
the display position will be offset from the center. For the vertical trend display, up to six
characters can be displayed. For the horizontal trend display, up to four characters can be
displayed.
• Trend > Scale > Dgt
Fine: If the scale value is displayed with two digits, it can be changed to three digits.
For example, if the scale range is 49.0 to 51.0, the scale values will be displayed with
three digits as shown below.
MV1000
MV2000
• Trend > Scale > Value ndcator
The current value is indicated with a mark or a bar.
Bar
6.7 Dsplayng a Scale on the Trend Dsplay