Yokogawa DA100 User Manual
Yokogawa Sensors
Advertising
Table of contents
Document Outline
- TABLE OF CONTENTS
- CHAPTER 1 OVERVIEW AND SPECIFICATIONS OF GP-IB INTERFACE
- CHAPTER 2 OVERVIEW AND SPECIFICATIONS OF RS-232-C INTERFACE
- CHAPTER 3 OVERVIEW AND SPECIFICATIONS OF RS-422-A/RS-485 INTERFACE
- CHAPTER 4 OVERVIEW AND SPECIFICATIONS OF ETHERNET INTERFACE
- 4.1 Introduction of Functions (Ethernet)
- 4.2 Specifications
- 4.3 Names and Functions of Each Section
- 4.4 Setting the IP Address
- 4.5 Connection Methods
- 4.6 Checking the Connection (Loopback test)
- 4.7 Transferring the Instantaneous Values
- 4.8 Displaying the Communication Information
- 4.9 Setting the Timeout
- CHAPTER 5 COMMAND FORMAT
- CHAPTER 6 COMMANDS
- CHAPTER 7 OUTPUT FORMAT
- 7.1 Functions as Talker
- 7.2 Measured/Computed Data Output Format (ASCII code)
- 7.3 Measured/Computed Data Output Format (Binary code)
- 7.4 Setting Data Output Format (Operation mode)
- 7.5 Setting Data Output Format (Setup mode)
- 7.6 Output Format for Unit and Decimal Point Position
- 7.7 System Configuration Output Format
- 7.8 A/D Calibration Data Output Format
- 7.9 Report Output Format
- 7.10 Relay Condition Output Format (Operation mode)
- CHAPTER 8 SAMPLE PROGRAM
- APPENDIX
- Index