Yokogawa DA100 - Manual (Page 5)

4 IM DA100-11E
TABLE OF CONTENTS
Communication Input Data Setting (CM)
Setting hourly/daily/monthly report to ON/OFF and the time to create the report (RO : with optional
report function)
Setting report channel to ON/OFF and the report computation type (RM : with optional report function)
Sample rate Setting (XV)
A/D Integration setting (XI)
Filter setting (XQ)
Setting Related to Alarm (XA)
Relay Reflash Setting (XY)
Relay AND/OR Setting (XN)
Relay Energizing/Deenergizing Setting (XD)
Relay Hold Setting (XH)
burnout Setting (XB)
Reference Junction Compensation Setting (XJ)
Setting of Computation Error Handling Method (XG)
Selecting the Relay for External Operation (VS)
Setup Setting Data Establishment (XE)
Temeprarure Unit Setting (XT)
A/D Caribratin (XZ)
6.2 Control Execution Command ......................................................................................................................... 6-7
Alarm Reset (AR)
Timer Reset (IR)
Computation Start/Stop/Reset/Clear (EX)
Executes the initial balancing of the strain input channel (BL)
Report start/stop (DR : : with optional report function)
System Reconstruction (RS)
RAM Clear (RC)
Setting Mode Selection (DS)
Relay ON/OFF (VD)
6.3 Data Output Request Command ..................................................................................................................... 6-8
Selection of Talker Output Data (TS)
Measured Data Output Request (FM)
Setting Data Output Request (LF)
Report data output request (RF : with optional report function)
Sysytem Configuration Data Output Request (CF)
Relay Condition Output Request (VF)
Byte Output Order Specification (BO)
Interrupt Mask Specification (IM)
Axuiliary Mask Specification (SM)
CHAPTER 7 OUTPUT FORMAT
7.1 Functions as Talker ......................................................................................................................................... 7-1
7.2 Measured/Computed Data Output Format (ASCII code) ............................................................................... 7-2
7.3 Measured/Computed Data Output Format (Binary code) .............................................................................. 7-3
7.4 Setting Data Output Format (Operation mode) .............................................................................................. 7-4
7.5 Setting Data Output Format (Setup mode) ..................................................................................................... 7-5
7.6 Output Format for Unit and Decimal Point Position ...................................................................................... 7-6
7.7 System Configuration Output Format ............................................................................................................ 7-7
7.8 A/D Calibration Data Output Format ............................................................................................................. 7-8
7.9 Report Output Format ..................................................................................................................................... 7-9
7.10 Relay Condition Output Format (Operation mode) ...................................................................................... 7-16
CHAPTER 8 SAMPLE PROGRAM
8.1 GP-IB Sample Programs ................................................................................................................................. 8-1
8.2 RS-232-C Sample Programs ........................................................................................................................... 8-4
8.3 RS-422-A/RS-485 Sample Programs ............................................................................................................. 8-7
8.4 Ethernet Sample Programs ............................................................................................................................. 8-7