Yokogawa DA100 - Manual (Page 45)

IM DA100-11E 5-3
Command Format
5
5.2 Command Syntax
In this manual, each command is explained as shown below.
SD Set date & time.
Mode Operation mode
Set SDp1, p2<terminator>
p1 year, month, day
p2 hour, min., sec.
Ex. Set the clock inside the DA to July 1, ’96, 13:00:00
SD96/07/01, 13:00:00
Comments • The formats of p1 and p2 are fixed to 8 characters.
Set them in the following manner.
p1=YY/MM/DD
p2=HH:MM:SS
Command function
Command
Effective command mode
Command syntax
Parameter description
Example of setting
Explanation of the way to
use and remarks in more detail
Mode
There are the following three modes in the DA100.
• Operation (measurement) mode
Mode to perform normal operation (measurement).
• Setup mode
Mode to set the basic specifications for the DA100.
To confirm the settings, execute the XESTORE command. See the description for the XE
command.
• A/D calibration mode
Mode to execute calibration of the A/D module.
Each mode is selected by the DS command. For details, see DS Command on page 6-10.
Also in each mode, commands and parameters that can be set and parameters that can be output
differ. See the description for each command.