Yokogawa PC-Based MX100 - Manual (Page 429)

7-31
IM MX190-01E
DARWIN - Visual C++ -
7
CDAQDARWIN::setPULSE
Syntax
int setPULSE(int iRangePULSE, int chType, int startChNo, int
endChNo = 0, int spanMin = 0, int spanMax = 0, int scaleMin =
0, int scaleMax = 0, int scalePoint = 0, int bFilter =
DAQDARWIN_VALID_OFF);
Parameters
iRangePULSE Specify the pulse range.
chType Specify the channel type of the measurement channel.
startChNo Specify the start channel number.
endChNo Specify the end channel number.
spanMin Specify the left value of the span.
spanMax Specify the right value of the span.
scaleMin Specify the left value of the scale.
scaleMax Specify the right value of the scale.
scalePoint Specify the decimal point position for scaling.
bFilter Specify ON/OFF for the filter using a boolean value.
Description
Sets the specified pulse range to the measurement channels in the specified
channel range (specified by channel type, start channel number, and end channel
number).
This function executes the SR command of the DARWIN communication function.
It creates and sends the command and receives the response.
If the left and right values are the same, the span or scale designation is considered
omitted.
Return value
Returns an error number.
Reference
runCommand CDAQDARWINChInfo::toChRange
7.4 Details of the DARWIN Class