Yokogawa PC-Based MX100 - Manual (Page 998)

19-4
IM MX190-01E
Data Retrieval Functions
Function Command Class and Member Function
Meas data Meas ch TS, FM CDAQDA100:: measInstCh
(inst value) Comp ch TS, FM CDAQDA100:: mathInstCh
Ch info Meas ch TS, LF CDAQDA100:: measInfoCh
data Comp ch TS, LF CDAQDA100:: mathInfoCh
System configuration data TS, CF CDAQDA100:: updateSystemConfig
Report status TS,RF CDAQDA100:: updateReportStatus
Setup data
Declare Op. Sngl spec TS, LF CDAQDA100:: talkOperationChData
mode Specify rng TS, LF CDAQDA100:: talkOperationData
Setup Sngl spec TS, LF CDAQDA100:: talkSetupChData
mode Specify range TS, LF CDAQDA100:: talkSetupData
Cal Sngl spec TS, LF CDAQDA100:: talkCalibrationChData
mode Specify range TS, LF CDAQDA100:: talkCalibrationData
Get data in units of lines - CDAQDA100:: getSetDataByLine
Setup data is not stored, so it is retrieved in the same order as mentioned in
sections 7.2 and 7.3. In this case, status is not updated.
Channel information data and system configuration data are stored internally, but
the user can explicitly perform acquisition.
The report status is stored internally, but is not updated unless the user explicitly
acquires it.
19.2 Correspondence between the Functions and Class/Member Functions - DARWIN -