Lincoln Electric IM8001 PRODUCTION MONITORING 2.2 - Manual (Page 114)

Fault Detail Tab Chapter 5. Using Production Monitoring™
IM8001 Production Monitoring™ User Manual 5.41
Chart Report
The Chart report provides you with a graph of the fault data, as well as the list of faults, that occurred for
the single Welding Power Source or Group of power sources you have selected in the Asset Tree.
Figure 5.33 Downtime Chart Report
The top half of the report is a graph that displays how long the fault(s) was active and how many times the
fault(s) occurred.
The bottom half of the report is a list that summarizes the data for each fault. On the right, the system also
displays the criteria used to generate the data. Table 5.23 on page 5.40 explains the columns of the report
in more detail.
Fault Detail Tab
The Fault Detail tab (Figure 5.35 on page 5.43) displays details for each occurrence of a fault and provides
specific information that was collected about the occurrence, including the time it happened and what
could have caused it.
TIP | The data in the Fault column of the Downtime report
contains a link that will bring you to the Fault Detail report
for that specific fault automatically when you click it.
Fault Detail Criteria
In general, the Downtime report brings you to the Fault Detail report and automatically enters appropriate
criteria for you. If you want to generate the report manually, you can customize the data based on several
criteria options. Simply click the Criteria link, enter your selections and click Save.