Lincoln Electric IM8001 PRODUCTION MONITORING 2.2 - Manual (Page 76)

Overview of the Application Chapter 5. Using Production Monitoring™
IM8001 Production Monitoring™ User Manual 5.3
If the system can’t display all of the tabs on the screen, you will see left and right arrow buttons ( ) to
the very right of the last visible tab. Simply click the correct navigation button until you see the tab you
want to access.
There are several different types of reports available in Production Monitoring™:
ƒ Current Status (page 5.7)
ƒ Production (page 5.10)
ƒ Weld Listing (page 5.21)
ƒ Weld Detail (page 5.30)
ƒ Traceability (page 5.35)
ƒ Downtime (page 5.39)
ƒ Fault Detail (page 5.41)
Individual Reports
The heart of Production Monitoring™ is the individual reports you have available under each Report tab.
Production Monitoring™ collects welding data from each weld produced by each Welding Power Source
that your administrator connected to the system. Depending if you have a single Welding Power Source
selected or a Group of power sources selected, the individual reports available to you varies.
Figure 5.4 Example Production Reports
For example, if you select a single Welding Power Source, the reports available on the Production tab are:
Grid, Weld Profiles, WeldScore™, Current/Voltage, Wire Feed Speed, True Energy™, and Duration/Count.
However, if you select a Group of power sources, the only reports available on the Production tab are:
Grid, True Energy™ and Duration/Count.
TIP | In-depth information about each report begins on page 5.7.
Panel Resize
To the right of the Asset Tree and under the Individual Reports are the Panel Resize bars. When you click
and drag the bar with your mouse, you can increase or decrease the size of the areas on either side of the
bar.