Lincoln Electric IM8001 PRODUCTION MONITORING 2.2 - Manual (Page 94)

Weld Listing Tab Chapter 5. Using Production Monitoring™
IM8001 Production Monitoring™ User Manual 5.21
overlays the number of welds performed during that period. The Period depends on the selections made
on the Criteria window. See page 5.11 for details on the fields of the Criteria window.
The bottom half of the report is a tabular list of the data. On the right, the system also displays the criteria
used to generate the data. Table 5.11 explains the columns on this report in more detail.
Table 5.11 Columns on Duration/Count Report
Column Description
Period The Period column reflects the choice made in the Group Welds drop-down on the
Criteria window, as well as the Start Date/End Date range and Shift selected.
To generate a new, more detailed report for a specific Period in the report, click
the link. The system automatically generates the Grid report on the Welding
Listing tab for you (page 5.23).
Total Arc Time The Total Arc Time is the total number of hours that the Welding Power Source or
Group of power sources you selected in the Asset Tree were spent in the Welding
state during the time period listed in the Period column.
Welds The Welds column displays the total number of welds performed during the time
period listed in the Period column.
Out of Limits The number in the Out of Limits column reflects the number of welds performed
that went outside of the limits set for the Weld Profile used for the weld. If no
Weld Profile limits were enabled, this column displays a zero. If a Weld Profile with
limits enabled was selected for only some of the welds, this column may be
skewed accordingly.
Weld Listing Tab
The Weld Listing reports display detailed information about each individual weld, both for a single Welding
Power Source and a Group of power sources. People such as Weld Engineers will find these reports
especially useful for reviewing all the attributes of the welds performed on the production floor.
With the Weld Listing reports, the same reports are available whether you have selected a single Welding
Power Source or a Group of power sources in the Asset Tree.
Criteria for the Weld Listing Reports
The criteria available for each of the Weld Listing reports are the same, including whether you have
selected a single Welding Power Source or a Group of power sources. Table 5.12 explains all the fields in
more detail. For more in-depth information on report criteria in general, please see page 5.11.