HT instruments SOLAR I-V - Manual (Page 62)

I-V400 - SOLAR I-V
EN - 60
7.3.2. Recall data of I-V curve tests at display
1. Press ESC/MENU key to back to the main menu, select
the “MEM” item and confirm with ENTER to access inside
the section od saved data
2. Using arrows keys (
,) and the arrow key  select the
item “Recall”, the item “I-V Test” and confirm with ENTER
for the visualization of I-C curve results only
3. The “DATA” label means the date/hour od saved data on
meter
15/05/10 15:34:26
MEM DATA
001 08/04/2010 10:38
002 13/04/2010 12:15
Y i e l d T e s t
V i e I - V T e s t
R e c a l l
D e l e t e 
Select MEM I - V
4. Use arrow key
 to select the “Comments” label
5. The description gives by the user during the data saved
operation (see § 7.2) is displayed
6. The symbol “*” near the number of measure means that
the meter have performed the I-V curve test with recording
of irradiance/temperature values by use of remote unit
SOLAR-02, but this values did not transferred or are not
available. For this measurements the translated STC
values won’t be available
15/05/10
15:34:26
MEM Comments
001 MODULE # 1
002* MODULE # 2
Select MEM I - V
7. By means of the arrow key
, select the “parameters”
label.
8. The markers relevant to Installation, String and Module
selected by the user during the saving procedure (§ 7.2)
are shown on the display.
9. Press ESC/MENU to exit the screen and to go back to the
main menu.
15/05/10
15:34:26
MEM IMP STR MOD
001 0 0 1 0 0 1 0 0 1
002 0 0 1 0 0 1 0 0 2
Select MEM – IV