KROHNE IFC 110 Converter - Manual (Page 42)

Sect. 5.5 Part B IFC 110 F Signal converter
42 IFC 110 F 05/2003
Setting of totalizer format
• Auto (exponent notation)
• # . ####### • ##### . ###
• ## . ###### • ###### . ##
• ### . ##### • ####### . #
• #### . #### • ########
Select with ↑ and ↓ keys.
Press ↵ key to change to subfunction ”DISP. MSG.”.
→ DISP. MSG. = additional messages desired in measuring mode, press → key
• NO (no additional messages)
• YES (display additional messages, e.g. errors, in sequence with measured values)
Select with ↑ and ↓ keys.
Press ↵ key to return to Fct. 1.04 DISPLAY
Note: ”BUSY” is displayed in measuring mode when all displays are set to ”NO DISP.” or ”NO”.
Sequencing of displays is automatic. In measuring mode, however, keys - and ¯ can be used
for manual sequencing. Return to automatic sequencing after approx. 3 minutes.
Please refer to Section 2.7 ”Factory settings”
5.5 Internal electronic totalizer
The internal electronic totalizer counts in m³ regardless of the unit set in Fct. 1.04, subfunction
”DISP. FLOW”.
The counting range depends on the meter size and has been selected such that the totalizer will
count for at least 1 year without overflow.
Meter size
Counting range
DN mm Inch in m³ US Gal equivalent
2.5 - 50 1 /
10
- 2 999 999.99999999 0 - 264 172 052.35800
65 - 200 2
1
/
2
- 8 9 999 999.9999999 0 - 2 641 720 523.5800
250 - 600 10 - 24 99 999 999.999999 0 - 26 417 205 235.800
700 -1000 28 - 40 999 999 999.99999 0 - 264 172 052 358.00
Only part of the totalizer count is shown in the display as it is not possible to display a 14-digit
number. Unit and format of the display are freely selectable. Refer to Fct. 1.04, subfunction ”DISP.
TOTAL.” and Section 5.4 to determine which part of the count is to be displayed. Display overflow
and totalizer overflow are independent of one another.
Example
Internal count
0000123 . 7654321 m³
Format, display unit XXXX . XXXX liter
Internal count in unit 0123765 . 4321000 liter
Displayed 3765 . 4321 liter