KYORITSU 1062 - Manual (Page 27)

85
4.3.3 DC+AC Voltage Measurement ( + )
1) Turn the function switch to the “ V ” position.
2) Press the SELECT key to select DC+AC voltage measurement.
(The display shows the “ + ” symbol.)
3) Plug the test leads into the input terminals.
4) Connect the test leads to the circuit under test and then read the value
when it stabilizes.
Test leads
Red Black
4.3.4 DC, AC Voltage Dual Display ( • )
1) Turn the function switch to the “DCV” position.
2) Press the SELECT key twice to change the mode to DC/AC voltage dual
display.
DC voltage measurement appears on the main display and AC voltage on
the sub-display.
3) Plug the test leads into the input terminals.
4) Connect the test leads to the circuit under test and then read the value
when it stabilizes.
Test leads
Red Black
4.3.5 Resistance Measurement (Ω)
CAUTION
To avoid damage to instrument
Turn off the power to the circuit under test before starting measurement in order to prevent any
excessive voltage from being applied to the instrument.
1) Turn the function switch to the “Ω ” position.
2) Plug the test leads into the input terminals.
3) Connect the test leads to the circuit under test and then read the value
when it stabilizes. Test leads
Red Black
Note
Zero adjustment
Zero adjustment is recommended for correct measurement. After executing 1), 2) above,
short the two test leads. Press the REL key for adjust. (The display shows the “0.0Ω”
value.) The value (zero adjustment) stores till turn off.