KYORITSU 1062 User Manual
Page 36
94
4.3.17 AUTO HOLD Function
The instrument can automatically retain the measured value
when the test leads are handled as described below.
1) Press the HOLD key to select Auto hold function.
(The display shows the“ A•H ” symbol.)
2) Connect the test leads to the circuit under test.
3) When the reading stabilized, the buzzer sounds.
4) Remove the test leads from the circuit under test.
5) The display shows the measured value that is retained.
You can repeat steps 2) to 4)as many times as you like as long as the display shows the “ A•
H ” symbol.
Note
• In DC/AC voltage measurement, the Auto hold function is only available for ranges greater
than the 5V range.
• This function is not available for Temperature, Capacitor and Frequency measurement.
• The Auto hold function can not be applied to unstable signals.