KYORITSU 1062 - Manual (Page 28)

86
4.3.6 Low Power-Ω (LP-Ω)
This function is for measuring the resistance of parts on a printed board under low measurement
current.
In Low Power-Ω measurement, up to 5,000 counts are displayed and the measurement range
is from 5 kΩ to 5 MΩ.
1) Turn the function switch to the “Ω” position.
Press the SELECT key to set LP-Ωmode. “LP-Ω” appears on the display.
2) Plug the test leads into the input terminals.
3) Connect the test leads to the resistance and then read the value when it
stabilizes.
Test leads
Red Black
4.3.7 Continuity Check ( )
CAUTION
To avoid damage to instrument
Turn off the power to the circuit under test before starting measurement in order to prevent any
excessive voltage from being applied to the instrument.
1) Turn the function switch to the “ ” position.
2) Plug the test leads into the input terminals.
3) Connect the test leads to the circuit under test. If the circuit is continuous
(no more than approximately 100Ω), the buzzer sounds.
Test leads
Red Black