Martel Electronics 3001 - Manual (Page 58)

10.4 Remote Command Listing
The following is an alphabetical list of all 3001 remote commands and queries, including
the common commands and the device-dependent commands. Each command title
includes a checkbox that indicates the remote interface applicability, IEEE-488 and/or RS-
232, and the command group, Sequential or Overlapped; see section 9.6.1 for a
description of these terms.
*CLS IEEE-488 RS-232 Sequential Overlapped
Clear Status command. This command clears the ESR, the error queue, and the RQS bit
in the status byte. This command terminates any pending operation complete
commands, *OPC or *OPC?.
Parameter: <None>
Response: <None>
Example: *CLS
This example clears the ESR, the error queue, and the RQS bit in the
status byte.
*ESE IEEE-488 RS-232 Sequential Overlapped
Event Status Enable command. This command loads a byte into the Event Status
Enable (ESE) register. See the Event Status Enable Register (ESE) description in section
9.7.
Parameter: <value>
where <value> is the decimal equivalent of the ESE byte, 0 to 255
Response: <None>
Example: *ESE 140
This example loads decimal 140 (binary 10001100) to enable bits 7
(PON), 3 (DDE) and 2 (QYE).
*ESE? IEEE-488 RS-232 Sequential Overlapped
Event Status Enable query. This command returns the contents of the Event Status
Enable (ESE) register. See the Event Status Enable Register (ESE) description in section
9.7.
Parameter: <None>
Response: <value>
where <value> is the decimal equivalent of the ESE byte, 0 to 255
Example: *ESE?
133
This example returns decimal 133 (binary 10000101) which indicates
that bits 7 (PON), 2 (QYE), 1 (OPC) are enabled.
X X X
X X X
X X X
54