Martel Electronics DMC1410 - Manual (Page 105)

103
11. Maintenance / Warranty
11.1 Replacing Batteries
Replace batteries as soon as the battery indicator turns on to avoid
false measurements. If the batteries discharge too deeply the
DMC1410 will automatically shut down to avoid battery leakage.
Note: Use only AA size alkaline batteries or optional rechargeable
battery pack.
11.2 Cleaning the Unit
Warning
To avoid personal injury or damage to the calibrator, use only the
specified replacement parts and do not allow water into the case.
Caution
To avoid damaging the plastic lens and case, do not use solvents or
abrasive cleansers.
Clean the calibrator with a soft cloth dampened with water or water
and mild soap.
11.3 Service Center Calibration or Repair
Only qualified service personnel should perform calibration, repairs,
or servicing not covered in this manual. If the calibrator fails, check
the batteries first, and replace them if needed.
Verify that the calibrator is being operated as explained in this
manual. If the calibrator is faulty, send a description of the failure with
the calibrator. Be sure to pack the calibrator securely, using the
original shipping container if it is available. To return the product to
Martel go to www.martelcalibrators.com and click on the Customer
Service link. Download the RMA form and follow the instructions.
Calibration procedures and other related documents can also be
found on the website.
11.4 Replacement Parts & Accessories
OTS-100 Portable Certificate Printer
CPTR1 Replacement printer interface cable for OTS-100
BPPA-100 BETA Pressure Module Adapter
80029 JKTE T/C Wire Kit, Mini Plugs
80036 RSNB T/C Wire Kit, Mini Plugs
CC909 Optional Deluxe Carrying Case
C232SJ RS232 Cable with Miniature Plug