Martel Electronics DMC1410 - Manual (Page 93)

9.6 Erase Menu
All Tags
Erase all tag configurations from the calibrator. Both list boxes
are cleared after the erasure. Use the Configure menu to select
the communications port.
Selected Tags
Erase selected tag configurations from the calibrator. Before
using this function, upload a list of the tag configurations
contained in the calibrator into the Tag ID's list box using the Tag
ID's function on the Upload menu. In the Tag ID's list box,
highlight the tags which are to be erased, and then select this
function to erase them. The Reports list box is cleared, and the
Tag ID's list box is updated after the erasure. Use the Configure
menu to select the communications port.
Multiple individual tags are selected by holding down the Ctrl
key and clicking on them one at a time. Multiple contiguous
tags are selected either by clicking on the first and dragging to
the last, or by clicking on the first and holding down the Shift key
while clicking on the last.
9.7 Download Menu
Tag
Select and download a single tag to a calibrator. The tag ID
must be unique within the calibrator or the tag will not be
downloaded. Use the Configure menu to select the
communications port.
Once the download begins, click the Cancel button in the
displayed status box to terminate the download.
Group
Select a group from which to select multiple tags for download
to the calibrator. Highlight all of the tags in the list which are to
be downloaded, then click OK. Multiple individual tags are
selected by holding down the Ctrl key and clicking on them one
at a time. Multiple contiguous tags are selected either by
clicking on the first and dragging to the last, or by clicking on the
first and holding down the Shift key while clicking on the last.
Any tag ID which is not unique within the calibrator will not be
downloaded. Use the Configure menu to select the
communications port.
During download a status display shows the progress, and
91