West Control Solutions KS 92-1 - Manual (Page 80)

11.1 Resetting to factory setting,
or to a customer-specific data set
In case of faultyconfiguration, the device can be reset to a default condition.
Unless changed, this basic setting is the manufacturer-specific controller default
setting.
However, this setting may have been changed by means of the BlueControl
®
software. This is recommendable e.g. when completing commissioning in order
to cancel accidental alteration easily.
Resetting can be activated as follows:
–
Press keys
È and Ì simultaneously FACtory is displayed after power
on, after approx. 2 seconds, the display changes to
FACno.
–
Keys
È and Ì can be used for switch-over between no and yEs in the
second line.
–
When pressing the Enter key with ”
no”, the unit starts without copying the de-
fault data.
–
When pressing the Enter key with ”
yEs”, there are four possibilities:
Safety hints
Resetting to factory setting, 80 KS 90-1 / KS 92-1
ÌÈ
+ Power on
1 2
È
1. 2.
FAC
Tory
FAC
no
FAC
YEs
1 2 3 4
FAC
COPY
FAC
COPY
FAC
PASS
8.8.8.8.
8.8.8.8.