Milestone XProtect Advanced VMS 2014 - Manual (Page 111)

Milestone XProtect ® Advanced
VMS 2014
Administrator's Manual
www.milestonesys.com 111 Management Client elements
1. Select the patrolling profile in the Profile list.
2. Select the preset position for which you want to change the time:
3. Specify the time in the Wait time (sec.) field:
4. If required, repeat for other preset positions.
Customize transitions
By default, the time required for moving the camera from one preset position to another, known as
transition, is estimated to be three seconds. During this time, motion detection is by default disabled
on the camera, because irrelevant motion is otherwise likely to be detected while the camera moves
between the preset positions.
You can only customize speed for transitions if your camera supports PTZ scanning and is of the type
where preset positions are configured and stored on your system's server (type 1 PTZ camera).
Otherwise the Speed slider is grayed out.
You can customize the following:

The estimated transition time

The speed with which the camera moves during a transition

Which plug-ins to disable during transition.
To customize transitions between the different preset positions:
1. Select the patrolling profile in the Profile list.
2. Select the Customize transitions check box:
Transition indications are added to the list of preset positions.