Milestone XProtect Advanced VMS 2014 - Manual (Page 83)

Milestone XProtect ® Advanced
VMS 2014
Administrator's Manual
www.milestonesys.com 83 Management Client elements
If the list appears to be incomplete:
1. Right-click the relevant remote server in the Overview pane and select Update Hardware.
2. The dialog box lists all changes (devices removed, updated and added) in the remote system
since you established or last refreshed the Milestone Interconnect setup. Click Confirm to
update your central site with these changes.
Remote Retrieval tab
On the Remote Retrieval tab, you can handle remote recording retrieval settings for the remote site in
a Milestone Interconnect setup:
Specify the following properties:
Name Description
Retrieve recordings at max
Determines the maximum bandwidth in Kbits/s to be used for
retrieving recordings from a remote site. Select the check box to
enable limiting retrievals.
Retrieve recordings between
Determines that retrieval of recordings from a remote site are
limited to a specific time interval.
Unfinished jobs at the end time continue until completion, so if the
end time is critical, you need to set it earlier to allow for unfinished
jobs to complete.
If the system receives an automatic retrieval or request for retrieval
from the XProtect Smart Client outside the time interval, it is
accepted, but not started until the selected time interval is reached.
You can view pending remote recording retrieval jobs initiated by
the users from System Dashboard -> Current Tasks.
Retrieve on devices in parallel
Determines the maximum number of devices from which recordings
are retrieved simultaneously. Change the default value if you need
more or less capacity depending on your system's capabilities.
When you change the settings, it may take several minutes until the changes are reflected in the
system.
None of the above applies to direct playback of remote recordings.
All cameras set to be played back directly is available for direct playback and use bandwidth as
needed.
Remove a recording server
Important: If you remove a recording server, all configuration specified in the Management Client is
removed for the recording server, including all of the recording server's associated hardware
(cameras, input devices, and so on).