HP Systems Insight Manager - Manual (Page 378)

NOTE: Click to view specific port details.
Port Details
•
Element Name The port name
•
WWN The port's World Wide Name
•
Port Type The port type (see “Port types” for additional information about port types.)
•
LUN Count The number of connections made through this port
•
Status The port's WBEM operational status (see “WBEM operational status types” for additional
information about WBEM status.)
Storage Volumes
NOTE: This section can be expanded by clicking or collapsed by clicking .
This section lists the array's storage volumes. Storage volumes are logical volumes on an array (for example,
LUNs).
•
Volume Name The storage volume name.
•
Visible to Host(s) The storage volume is accessible to the listed hosts.
•
Block Size The storage volume's block size in bytes.
•
Number of Blocks The total number of blocks on the storage volume.
•
Total Size The storage volume's total size.
•
RAID Level The RAID level of the storage volume. Typically, this value is supplied by the array's SMI-S
provider. If the SMI-S provider does not supply a value, HP Systems Insight Manager calculates the
RAID level based on the values for Package Redundancy and Data Redundancy as follows:
RAID level Data redundancy Package redundancy
RAID 0 1 0
RAID 5 1 1
RAID 1 2 1
RAID 6 1 2
RAID 15/51 2 2
If the RAID value is calculated by HP Systems Insight Manager, an asterisk is added to the RAID value
(for example RAID 5*).
Capacity Information
NOTE: This section can be expanded by clicking or collapsed by clicking .
The Capacity Information table lists the available capacity metrics for storage arrays in the Metric column
and the corresponding disk space value in the Size column. For each metric, the disk space value is expressed
as a percentage of the array's total capacity. The metrics in the Capacity Information table are also
displayed as percentages in a pie chart below the table. If any value in the table shows an Undetermined
value, the pie chart is not displayed.
378 Tools that extend management