HP Systems Insight Manager - Manual (Page 620)

Description Data Type Column Name
Flag indicating if this system supports HTTP-based
management; a value of -1 indicates the system was not
yet identified; a value of 0 indicates HTTP was not found
on the system a value of 1 indicates that HTTP was found
on the system INT HTTP
Flag indicating if this system supports DMI-based
management; a value of -1 indicates the system was not
yet identified; a value of 0 indicates DMI was not found on
the system; a value of 1 indicates DMI was found on the
system INT DMI
Always 2.0. NCHAR(32) DMIVerStr
If WBEM is detected on the system, then this is set to 1;
otherwise, it is set to 0 INT WBEM
The version of WBEM that HP SIM found on the system NCHAR(32) WBEMverStr
If SSH was detected on the system this is set to 1; otherwise,
it is set to 0 INT SSH
The System ID returned from the SSH request NCHAR(64) SSHverStr
For future expansion. nchar(32) PrimaryAddress
The device key of the system that is used for the WMI proxy
for the system for this record (In other words HP SIM uses
the system with same device key as the WMIProxyID for
making WBEM to requests through the WMI Mapper
running on that other system.) INT WMIProxyID
ExtentStatus_values table
Description Data Type Column Name
Used for reporting purposes BIGINT ExtentStatusId
Used for reporting purposes SMALLINT ExtentStatusValue
Used for reporting purposes INT ExtentStatusPos
DeviceSnmpSettings table
The DeviceSnmpSettings table contains the SNMP settings currently configured for the systems. The
DeviceSnmpSettings fields are defined in the following table.
Description Data Type Column Name
Associates a system with its collected set of data (This system
information is linked using the DeviceKey from the devices
table.) INT *DeviceKey
The network timeout value in seconds INT networkTimeout
The number of retries to be used for SNMP requests INT networkRetries
ICMP ping timeout value in seconds INT icmpTimeout
The number of ICMP ping retries to perform INT icmpRetries
Defines if this system uses defaults (Global protocol settings)
for some or all protocols or its individual settings (This is a
bitmask field where the different bits define what defaults
are to be used. The values are logically ordered together:
1= use the default SNMP read community, 2 = use the
default SNMP write community, 4 = use the default SNMP
timeout, 8 = use the default SNMP retries, 16 = use the
default icmp timeout, 32 = use the default ICMP retries, 64
= use the default WBEM user name, 128 = use the default
WBEM password) INT defaultProtoMask
620 Reference information