Service notification events, Host configuration and setup – HP Systems Insight Manager User Manual
Page 483
Where
quanit1 is the system name.
Related procedures
•
•
Creating an automatic event handling task
•
Configuring event filters for registered SNMP traps
•
Configuring modem settings for paging
•
Related topic
▲
Service notification events
The HP Services analysis tools,
(WEBES), and
(OSEM), generate service notifications to HP Systems Insight Manager (HP SIM) through a specific
type or
(SOAP) event if analysis has determined that there are serviceable
events.
The SNMP trap capability is supported in WEBES 4.4.1 or later and OSEM 1.3 or later, and has been part
of HP SIM since version 4.0. The SOAP event notification is supported with WEBES 5.0, OSEM 1.4.1, and
HP SIM 5.1.
To download these tools and for installation instructions, go to
.
OSEM can also be obtained from the
Smart Start Management CD.
If
Service Essentials Remote Support Pack
is installed, the service notification provided by WEBES and OSEM
also provides status about remote support incidents. See
“HP Service Essentials Remote Support Pack”
for
more information about Remote Support Pack.
Host configuration and setup
No special setup of OSEM is required as long as these tools are on the same system as HP SIM because
the service traps are normally sent to
localhost by default and you accept the default SNMP settings. If OSEM
is on a separate system from HP SIM, you must perform the procedure outlined in the
How to Change the
HP SIM Host Name section of the OSEM Installation Guide.
In the case of WEBES, enter desta snmp from the operating system command line.
You are prompted for the system to send the service traps to and you must enter the HP SIM system name
regardless of whether WEBES and HP SIM are on the same system.
Events 483