HP Designjet 8000 Printer series - Manual (Page 194)

● FINE DRAFT — fine draft print mode (540 x 720 dpi – 6 passes).
● 3 TIMES — high quality, high density print mode (720 x 720 dpi – 24 passes).
Media back feed adjustment value
Use this option to set the value for media back feed that you obtained from the back feed adjustment pattern.
Parameters: ±2000 pulse (±5 mm)
1 pulse = 2.5 µm
The PH. MAIN menu
Use the PH. MAIN menu to maintain the cap, the wiper and to clean the ink system. For details, refer to
How do I maintain the printer .
Press the key to enter the printhead maintenance menu.
Ink system optimization (INK SYS OPT)
Use the INK SYS OPT option to select a service cleaning procedure.
Parameters:
● STORE INK SYS — use this parameter to clean the printheads and ink path for storage.
● CLEAN INK SYS — use this parameter to clean the printheads with the cleaning liquid after storage.
● CHARGE INK SYS — use this parameter when priming the ink system.
● CHARGE NEW PH — use this option if a printhead has been replaced and it is not printing correctly.
Cap cleaning (CAP CLEANING)
Use this option to move the printhead carriage to the wiper position so that you can clean the capping unit
manually, check and replace the wiper liquid, and replace the wiper sponge.
184 Chapter 14 Tell me about… (menus) ENWW
Tell me about… (menus)