HP Designjet 8000 Printer series User Manual
Page 66
If the pattern on the left edge of the media is not aligned with the groove when the pattern on the right edge
is aligned, use the take-up reel height screw (1) to adjust the take-up reel height up (2) or down (3).
Only the left side of the take-up reel can be adjusted up or down.
Adjust the height of the take-up reel as follows:
1.
If the take-up reel pattern on the left edge of the media is not aligned with the groove when the pattern
on the right edge is aligned, do one of the following:
a.
If the take-up reel pattern on the left side is higher than the groove (1), turn the take-up reel height
screw clockwise to raise the left side of the take-up reel.
b.
If the take-up reel pattern on the left side is lower than the groove (2), turn the take-up reel height
screw anti-clockwise to lower the left side of the take-up reel.
2.
After adjusting the height, check that the pattern is aligned with the groove on the left edge of the
media. Repeat step two until both ends of the pattern are aligned with the same groove.
56
Chapter 3 How do I load/unload media
ENWW
How
do
I load
/u
nlo
ad m
edi
a