HP Designjet 8000 Printer series User Manual
Page 37
Advertising
If the pinch wheels do not apply the same pressure on both edges, then do the following:
a.
Reposition the media so that the pressure is equal at both edges of the media:
●
Lower the media lever;
●
Loosen the stop screws on the media holders;
●
Adjust the position of the roll left or right along the support bar;
●
Tighten the stop screws on the media holders;
●
Raise the media lever.
NOTE
Take care that the media is flat and does not catch on the pinchwheels while
changing the position.
ENWW
Install a media roll in the printer
27
How do
I load
/u
nlo
ad m
edia
Advertising