HP Designjet 8000 Printer series - Manual (Page 62)

6. From the rear of the printer, tape (1) the edge of the media onto the core tube on the take-up reel.
Tape on both edges and in the center (1).
NOTE Make sure the media is attached to the correct side of the tube. You may wind the
media over the core tube for anti-clockwise winding, or under the core tube for clockwise
winding.
Attach the media to the core tube in a straight line so that media winding is even.
7. Manually turn the media hub (1) to wind some media onto the take-up reel. Remember to turn the
media hub in the same direction as the take-up reel winding direction for printing on the inside or the
outside of the roll.
52 Chapter 3 How do I load/unload media ENWW
How
do
I load
/u
nlo
ad m
edi
a