HP Designjet 8000 Printer series - Manual (Page 64)

b. Lower the tension bar (1) to the bottom position.
As you lower the tension bar, it will pull the extra media needed for the bottom position through
the media path.
c. At the front of the printer, lower the media lever (1).
You now need to perform media advance calibration. See How do I calibrate my printer
Take-up reel horizontal alignment
The height of the take-up reel may require adjustment as it must be horizontally aligned to the media output
from the printer. If you notice that the media is not winding on to the take-up reel correctly, and there is
skew, check that the media is loaded in the printer correctly and that the take-up reel is aligned. To verify
alignment of the take-up reel height you need to print the take-up reel test print.
The printer will print a line across the width of the media. Use this line to check the alignment of the right
side of the take-up reel with the left side. Use the take-up reel tension bar as the horizontal reference for
alignment.
Print the take-up reel pattern on roll media to ensure that there is sufficient length to feed the media to the
tension bar on the take-up reel.
54 Chapter 3 How do I load/unload media ENWW
How
do
I load
/u
nlo
ad m
edi
a