HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 228)

The following explains the action to be taken for each case.
When an Error Message Appears and the OS Stops
The probable causes of this error are as follows:
Cause 1
The initial RAM disk image file was specified incorrectly in the boot loader
configuration.
Cause 2
The initial RAM disk image file is corrupted.
Cause 3
The startup disk was no longer recognized first because the system
environment configuration was modified.
If the startup disk is not found due to the changes in the system
environment configuration, the following message appears:
To correct the above error:
1
.
Restart the host.
2
.
In the window for setting information about boot loader startup, select
the option for startup from a SCSI device.
If startup from the SCSI device fails, enable only the path to the LU on
which the OS is installed, and then start the OS.
3
.
Check the definitions in the /etc/lilo.conf file, /etc/grub.conf
file, /etc/elilo.conf file, or /boot/grub/menu.lst file to make sure
that the initial RAM disk image file and ramdisk_size are specified
correctly.
Modify any incorrect specification.
If startup from the HDLM device still fails after you correctly specify the
initial RAM disk image file and ramdisk_size, the initial RAM disk image
file might be corrupted. Execute the boot disk support utility to re-create
the initial RAM disk image file.
4
.
Restart the host to start the OS from the HDLM device.
When a Prompt for a Password for Starting Maintenance Appears, and the OS
Stops
The probable causes of this error are as follows:
3-156
Creating an HDLM Environment
Hitachi Dynamic Link Manager (for Linux®) User Guide