HP Hitachi Dynamic Link Manager Software Licenses - Manual (Page 509)

Key name #1 Description #2
Necessity of
definition
Maxim
um
numbe
r of
charac
ters
New
installa
tion
Upgrad
e
installa
tion or
re-
installa
tion
You can specify a check interval
from 1 to 1440. The default is 30.
auto_failback Specify one of the following values
to indicate whether to enable or
disable the automatic failback
function for failed paths:
on: Enabled (default)
off: Disabled
Optional Optional 3
auto_failback_inte
rval Specify the interval in minutes from
the time the previous path status
check finished until the time the
next path status check started.
You can specify a check interval
from 1 to 1440. The default is 1.
Optional Optional 4
intermittent_error
_monitor
#3
Specify one of the following values
to indicate whether to enable or
disable intermittent error
monitoring:
on: Enabled
off: Disabled (default)
Optional Optional 3
intermittent_error
_monitor_interval Specify the interval in minutes that
monitoring for intermittent errors is
performed.
You can specify a check interval
from 1 to 1440. The default is 30.
Optional Optional 4
intermittent_error
_monitor_number Specify the number of times an
error occurs. You can specify a
value from 1 to 99. The default is 3.
Optional Optional 2
dynamic_io_path_co
ntrol Specify whether to enable or
disable the dynamic I/O path
control function by using the values
below. Note that, if this function is
set, the setting for each storage
system or LU is cleared.
on: Enabled
off: Disabled (default)
Optional Optional 3
dynamic_io_path_co
ntrol_interval For the dynamic I/O path control
function, specify the checking
interval (in minutes) for reviewing
the information about the switching
Optional Optional 4
Utility Reference
7-49
Hitachi Dynamic Link Manager (for Linux®) User Guide