Setting up ilo by using the ilo web interface, Logging in to ilo for the first time – HP Integrated Lights-Out 3 User Manual
Page 21
3.
Press F8 in the HP ProLiant POST screen.
The iLO RBSU screen appears.
4.
Select User
→Remove, and then press Enter.
The Remove User screen appears, as shown in
.
Figure 7 Removing user accounts
5.
Select the user that you want to remove, and then press Enter.
The iLO RBSU prompts you to confirm the request.
6.
Press Enter to confirm the request.
7.
Select File
→Exit to exit iLO RBSU.
Setting up iLO by using the iLO web interface
You can use the iLO web interface to configure iLO if you can connect to iLO on the network by
using a web browser. You can also use this method to reconfigure an iLO management processor.
Access iLO from a remote network client by using a supported browser and providing the default
DNS name, user name, and password. For information about the DNS name and default user
account credentials, see
“Logging in to iLO for the first time” (page 21)
.
For information about the configuration procedures available in the iLO web interface, see
Logging in to iLO for the first time
The iLO firmware is configured with a default user name, password, and DNS name. Default user
information is located on the serial number/iLO information pull tab attached to the server that
contains the iLO management processor. Use these values to access iLO remotely from a network
client by using a web browser.
Setting up iLO by using the iLO web interface
21