HP Integrated Lights-Out 3 - Manual (Page 72)

•
Address list—This table shows the currently configured IPv6 addresses for iLO. It provides the
following information:
◦ Source—Indicates whether the address is a static or SLAAC address.
◦ IPv6—The IPv6 address.
◦ Prefix Length—The address prefix length.
◦ Status—The address status: Active (the address is in use by iLO), Pending (Duplicate
Address Detection is in progress for this address), or Failed (Duplicate Address Detection
failed and the address is not in use by iLO).
•
Default Gateway—The default IPv6 gateway address that is currently in use. For IPv6, iLO
keeps a list of possible default gateway addresses. The addresses in this list originate from
router advertisement messages and the IPv6 Static Default Gateway setting.
The Static Default Gateway setting is configured on the IPv6 page. For more information, see
“Configuring IPv6 settings” (page 76) .
Configuring general network settings
Use the iLO Dedicated Network Port or Shared Network Port Network General Settings page to
configure general network settings. You must have the Configure iLO Settings privilege to make
changes on this page.
1.
Navigate to the Network
→iLO Dedicated Network Port or Network→Shared Network Port
page.
2. Click the General tab, as shown in Figure 32 (page 72) .
Figure 32 Network General Settings page (iLO Dedicated Network Port)
72 Configuring iLO