HP Integrated Lights-Out 3 - Manual (Page 41)

NOTE: You can configure some of these settings by using iLO RBSU. For instructions, see “Using
the iLO RBSU” (page 87) .
To view or modify iLO access options:
1.
Navigate to the Administration
→Access Settings page.
2. Click the Access Settings tab and scroll to the Access Options section of the Access Settings
page, as shown in
Figure 17 (page 41) .
Figure 17 Access Options
3. Update the following settings as needed:
Table 2 Access options
Description Default value Option
This setting specifies how long a user can be inactive, in
minutes, before the iLO web interface and Remote Console 30 Idle Connection Timeout
(minutes)
session end automatically. The following settings are valid:
15, 30, 60, or 120 minutes, or Infinite. Inactive users are not
logged out when this option is set to Infinite.
Failure to log out of iLO by either browsing to a different site
or closing the browser also results in an idle connection. The
iLO firmware supports a finite number of iLO connections.
Misuse of the Infinite timeout option might make iLO
inaccessible to other users. Idle connections are recycled after
they time out.
This setting applies to local and directory users. Directory
server timeouts might preempt the iLO setting.
Changes to the setting might not take effect immediately in
current user sessions, but will be enforced immediately in all
new sessions.
The iLO network and communications with operating system
drivers are terminated when iLO functionality is disabled. Enabled iLO Functionality
If iLO functionality is disabled (including the iLO Diagnostic
Port), you must use the server Security Override Switch to
enable iLO. See the server documentation to locate the
Security Override Switch, and then set it to Override. Power
up the server, and then use the iLO RBSU to set iLO
Functionality to Enabled.
NOTE: The iLO functionality cannot be disabled on blade
servers.
Configuring iLO access settings 41