HP Integrated Lights-Out 3 - Manual (Page 86)

1. Navigate to the Administration
→Management page, as shown in
Figure 38 (page 86) .
Figure 38 iLO Management – SNMP Settings page
2. Enter the SNMP Alert Destinations in the Configure SNMP Alerts section. You can provide the
IP addresses of up to three remote management systems to receive SNMP alerts from iLO.
NOTE: Typically, you enter the HP SIM server console IP address in this section.
3. Click Apply.
Configuring Insight Management integration
1. Navigate to the Administration
→Management page.
2. Configure the HP System Management Homepage (HP SMH).
This value sets the browser destination of the Insight Agent link on iLO pages.
Enter the IP address or DNS name of the host server. The protocol (https://) and port
number (:2381) are added automatically to the IP address or DNS name to allow access
from iLO. If the URL is set through another method (for example, HPQLOCFG), click the browser
refresh button to display the updated URL.
3. Select the Level of Data Returned.
This setting controls the content of an anonymous discovery message received by iLO. The
information returned is used for HP SIM HTTP identification requests. The following options
are available:
•
Enabled (iLO+Server Association Data) (default)—Enables HP SIM to associate the
management processor with the host server, and provides sufficient data to enable
integration with HP SIM.
•
Disabled (No Response to Request)—Prevents iLO from responding to HP SIM requests.
4. Optional: Click View XML Reply to view the response that is returned to HP SIM when it
requests iLO management processor identification using the provided address.
5. Click Apply to save the changes.
For more information about the Insight Management Agents, navigate to the Information
→Insight
Agent page.
86 Configuring iLO