Insert m5 screw, Install rails, Figure 4 – HP StorageWorks 1000i Virtual Library System User Manual
Page 25
Advertising
11091
Figure 4 Insert M5 screw
d. Use a T-25 torque wrench or a #2 Phillips screw driver to tighten the M5 screws and secure
the rail to the rack.
e. Align holes at the other end of the rack with the rail assembly and secure with mounting
hardware.
5201b
Figure 5 Install rails
f. Repeat these tasks for the rail on the other side of the rack.
2.
Remove the inner slide rails from the outer slide rails. To do so, extend the inner slide rails from the
front of the rack until they lock in place. Then press the inner rail release latch (see
) and
pull the inner slide rails straight out.
HP StorageWorks 1000i Virtual Library System
25
Advertising