HP StorageWorks 1000i Virtual Library System - Manual (Page 45)

Figure 32 iSCSI initiator properties
12. Click OK.
The Microsoft iSCSI Initiator is now installed and configured to work with your VLS on this client. Repeat
this procedure on each client that will access the VLS.
Obtaining iSCSI address from host
Each device created is associated with one backup host. In order to use the VLS, backup hosts must be set
up as iSCSI initiators. See Deploying iSCSI initiators for instructions on deploying iSCSI initiators.
NOTE:
The following process presents associating devices and backup hosts using the Microsoft iSCSI Software
Initiator. The steps and screens may be different depending on the iSCSI solution on your system.
The following steps show how to associate devices with backup hosts.
1. On the host you want to associate with the device being created, select Start > Microsoft iSCSI
Initiator > Microsoft iSCSI Initiator.
2. The iSCSI Initiator Properties window displays. On the General tab is listed the Initiator Node
Name. See Figure 33 .
HP StorageWorks 1000i Virtual Library System 45