HP StorageWorks 1000i Virtual Library System - Manual (Page 47)

Figure 35 iSCSI Name
5. If you want to use an additional level of authentication, use dotted decimal notation to enter the IP
address of the host system in the iSCSI IP Enforcement field. This is optional.
6. Continue with Creating virtual devices .
Creating virtual devices
The VLS1000i has capacity for the following numbers of devices:
• 12 virtual tape drives (total of standalone drives and drives in virtual tape libraries)
• 6 virtual tape libraries
• 180 virtual cartridges total (up to 80 cartridges for each virtual tape library)
To select the type of device to create, perform the following steps:
1. Open the VLS GUI. See Opening a VLS GUI session from a web browser .
2. In the GUI, select Configuration > Create Virtual Device. See Figure 36 .
NOTE:
The Configuration screen defaults to the Backup Host Summary page and begins with no
devices listed. You must use Create Virtual Device.
Figure 36 Select type of device to create
3. Select the type of device to create by clicking either Virtual Library or Virtual Standalone Tape Device.
4. Continue with the next appropriate section—either Creating a standalone tape device or Creating
a tape library .
Creating a standalone tape device
Perform the following steps to finish creating a tape device:
1. Scroll down, if needed, in the Create Virtual Device pane until you see Device Details ( Figure 37 ).
HP StorageWorks 1000i Virtual Library System 47