HP StorageWorks 1000i Virtual Library System - Manual (Page 94)

Figure 82 Removing HDD from tray
Reverse the steps to install a new HDD.
RAID controller card
CAUTION:
Remove power to the server by disconnecting the power cord before removing or installing a RAID
controller card and riser assembly.
To remove the RAID controller card:
1. On the RAID controller card, disconnect the hard drive cables that connect to the SATA
backplane, and the power cable that connects to the system board.
2. Lift the riser card assembly out of the chassis. (The RAID controller card is connected to the
riser card assembly.)
Figure 83 Removing riser card assembly
3. Remove the screw securing the RAID controller card to the riser card assembly and pull the
controller card from the riser card assembly PCI-X slot.
94 Component replacement